Opening the way Phone Lock / Security Code Nokia

If you experience problems "Phone lock", then do not need to panic, because there are some initial steps that can be done to overcome that by entering the code standards that are usually used, namely 12345, 1234, 0000. 000,000 and 000,000,000. If not successful, try to figure free.

I worry about you made a mistake entering the code unless there is a display warning limit test cobanya, from experience, there are usually at the Siemens mobile phone.

Special to the Samsung phone reset EEPROM can be done directly by entering the code * # 2767 * 2878 in the conditions of life without the use of mobile phone simcard. If not successful then you can also bring to the service center to open the Phone Lock.

Generally, the improvements made by the software, to continue using the introduction of UFS Tornado then this edition we will try to provide step-by-step improvement of the software to overcome the problem of the phone is locked by a password code (Phone Lock)

Opening the Nokia Phone Lock
DCT-3 (3610, 2100, 8210, 8250, 3310, 3315 ... 6090)

* Connect your phone with UFS Tornado on the PC
* Make sure your phone is connected with a good menu click 'check' on the Tornado in a PC.
* Select DCT 3
* Click on the type of phone that will be in the Warlock.
* Click reset user lock 2x
* Then click on the full factory default 2x
* Wait until the OK
* Click Disconnect

Opening Phone Lock Nokia DCT-4
(8310, 3300, 3530, 3510, 7210, 3100 ...)

* Connect your phone with UFS Tornado
* Make sure your phone is connected with both
* Select DCT 4
* Click on a mobile phone that will be in the Warlock
* Click reset user lock 2x
* Then click on the full factory default 2x
* Wait until the OK
* Click Disconnect

Steps starters can you do to make improvements Phone Lockk to the type of mobile phone WD2 (N-Gage, N-GageQD, 3650, 3660, 6600, 7610, ...) and BB5 (6630, 6680, N70, N90 ...